ADVANCE88 ECU SOFTWARE

Here is the simple and secure method of update of your ECU with a new software version.

Documentation dowload


 

Download Adv88_ENU-2.0.0.0.zip

WARNING LEVEL : NORMAL

 

Graphical display

 


 

NEW FEATURES AND IMPROVEMENTS

Improvement of vehicle speed limiter:
• Addition of the possibility for the driver to increase or decrease the vehicle speed by the mean of two buttons.
• Vehicle speed limiter more efficient: faster reaction and smoother.
• See new document 'Advance88 Vehicle speed limiter configuration - V120' with full example of tuning.
 

Selection of cylinder 1 TDC for injection phase:
• P
ossibility to phase the injection in relation with the cylinder 1 exhaust TDC or in relation with the compression TDC.

Improvement of the possibility of manually modifying the mini-maxi calibration of motorized throttles:
• In case the throttle does not have strong minimum or maximum mechanical stops, the electric motor exceeds the normal min and max positions.
• When exceeding the normal maximum opening, the throttle gears are forced and the teeth of the plastic gear wear and destroy over time.

• See new document 'Advance88 Throttles and accelerator pedal configuration - V110'.

Smooth out jerks during foot lifts and rehitching (V190):
• particularly useful with multi-throttle engines which give significant jolts in these conditions.
• See new document 'Advance88 Ignition Throttle-rpm - V130'
.

Management of fuel high pressure pumps by external synchronous pulses (V190):
• For example on BMW S55 engines on which the pump turns faster than the crankshaft.
• The pump is equipped with a Hall effect sensor which gives a pulse at each pump piston TDC.

Improvement of variable camshaft management (V190):
• Correction of the command in function of the engine temperature and engine speed.
• Certain Toyota or Ford engines need a modified management at low engine temperature, under penalty of aberrant camshaft positioning.

Data transmission by CAN-Bus to DashBoards (V190):
• InjMin configuration (Injall reduced) now passes fuel pressure, oil pressure and oil temperature.

Improvement of the balance between cylinders for knock measurement (V180):
Accepts a larger difference between the cylinders signal levels.

Securization of engine synchronization in case of phase sensor failure (V180):
Synchronization is not performed if the Hall effect phase sensor only sends ground.

Memorization of performed engine protections (V170):
• T
he ECU saves the performed protections in a permanent memory (it therefore remembers the protections it has performed even if the ignition is switched off).
• 
This memorization allows to check what happened before when you were not connected to the ECU with the PC, for example why the engine was stopped or why the torque was reduced.

Improvement of fuel pressure protection (V170):
• A map gives the waiting time in seconds before engine stop protection when the fuel pressure drops below the minimum limit.
• This allows to not cutoff the engine on a simple oscillation of fuel pressure.

Improvement of twin turbos operation (V170):
When there are two twin turbos (1 per cylinder bank) and they are controlled by electric motor (like a VGT).

Improvement of turbos speed correction by Ethanol content (V170):
When the turbo speed is modified by the Ethanol content.

First version able to measure two potentiometer tracks on one main throttle (v160).
Previous versions measure two potentiometer tracks per throttle only for two bank 1 and bank 2 throttles.

Complete flex-fuel management with Ethanol content sensor (v150).

Machine gun Hard cut RPM limiter with burst of flames (v150).


CONTENT

Advance88 Tunewares:
• System V180 (new - 8th 01/2024)
• Throttle/RPM: V200 (new - 8th 01/2024)
• Pressure/RPM and turbo: V200 (new - 8th 01/2024)

Documentations in English:
• Advance88 tuning software pack: 52 separate documents, each for one specific fonction of the ECU, with many didactic examples (new - 8th 01/2024)
• Ethanol complete tuning and Hard cut rpm limiter documents
• Advance88 installation: V1.60 - with commands of ignition modules (new - 8th 01/2024)
• Advance88 options installation: V1.40 - sequential gearboxes, fly by wires, bang-bang, Vanos BWM ... (new - 8th 01/2024)

Nota:
• Does not contain Winjall software. Winjall must first be downloaded and installed apart.
• Does not contain the sensors convertion maps nor the actuators command maps. These maps have to be downloaded and installed apart with the pack SensAct.

 

LAST SECURITY CRITICAL MODIFICATION DONE

Not needed.

 

Button to launch the downloads

 

NEEDING Winjall V9.8.0.0 (see specific downloading)

V9.8.0.0 or later version of Winjall software must mandatory have been installed first.

 

HOW TO UPGRADE TUNEWARES

• Download new .zip Advance88 software pack file and save it in a directory on your hard disk.
• If you have already install a former version of this pack, you have to usinstall it before installing this new one:
In Windows XP, execute 'Start/Parameters/Configuration/Add-Remove programs'.
In Windows 7 and latter versions, execute 'Start/Parameters/Configuration/Programs and features'.
In the software list, select Commander88 then 'Uninstall'. Follow uninstall instructions.
• With the explorer, double click on the downloaded software pack .zip file, then double click on Setup. At the question on files extraction, answer 'Extract All'.
• If the installation does not automatically start: in the new directory created by the extraction, double click on Setup (application).

 

 


 

VERSIONS HISTORY
(Improvements are added from a version to the next one)

 

Throttle/RPM : V190 (System V170)
P
ressure/RPM : V190 (System V170)

1) Possibility of manually modifying the mini-maxi calibration of motorized throttles.
In case the throttle does not have minimum or maximum mechanical stops, the electric motor exceeds the normal min and max positions.
2) Smooth out jerks during foot lifts and rehitching:
Particularly useful with multi-throttle engines which give significant jolts in these conditions.
3) Management of fuel high pressure pumps by external synchronous pulses:
For example on BMW S55 engines on which the pump turns faster than the crankshaft.
4) Improvement of variable camshaft management:
Correction of the command in function of the engine temperature and engine speed.
5) Data transmission by CAN-Bus to DashBoards:
InjMin configuration (Injall reduced) now passes fuel pressure, oil pressure and oil temperature.


Throttle/RPM : V180 (System V160)
P
ressure/RPM : V180 (System V160)

1) Improvement of the balance between cylinders for knock measurement.
2) Securization of engine synchronization in case of phase sensor failure.


Throttle/RPM : V170 (System V150)
P
ressure/RPM : V170 (System V150)

1) Memorization of performed engine protections.
2) Improvement of fuel pressure protection.
3) Improvement of twin turbos operation.
4) Improvement of turbos speed correction by Ethanol content.


Throttle/RPM : V160 (System V140)
P
ressure/RPM : V160 (System V140)

1) First version able to measure two potentiometer tracks on one main throttle.
Previous versions measure two potentiometer tracks per throttle only for two bank 1 and bank 2 throttles.
2) 
Complete flex-fuel management with Ethanol content sensor.
3) Machine gun Hard cut RPM limiter with burst of flames.

 

Throttle/RPM : V150 (System V140)
P
ressure/RPM : V150 (System V140)

1) Complete flex-fuel management with Ethanol content sensor.
2) Machine gun Hard cut RPM limiter with burst of flames.

 

Throttle/RPM : V140 (System V140)
P
ressure/RPM : V140 (System V140)

Start version.

 

Top of page


HomeHome